Dice Dice Tower - aka Dice Dice Baby

Last crawled date: 4 years, 2 months ago

My humble take on the traditional dice tower. This dice tower features 4 baffles and enough room to bounce to give the dice plenty of opportunity for full randomization. The courtyard is modular. You can make it short to reduce the footprint, or print as many Courtyard Expansions as you would like to stretch it out and hold more dice. I split this into pieces to enable people with almost any size of print bed to be able to print it. The connection system works well for easy gluing horizontally or easy gluing and/or stacking vertically.
I designed the angles of the baffles to not need supports. I used supports for the large dice because of the round pips and the exit door, although after doing some test prints, I'm not sure they made much of a difference.
This tower is taller, standing at just under 9" and it can accomodate dice up to 28mm. You can scale it down and it should work fine if you are looking for something a bit smaller. I was going for more of an epic build for this one.
You will want to get some super glue or model glue for the courtyard at a minimum. I glued the whole thing but the top die and bottom die with the base plate wouldnt' technically need to be glued if you were looking to keep it modular for storage purposes. I used Tamiya primer and paint for this model. Spray paint for the base layer on everything and then followed up with black semi gloss for the die pips.
Lastly and unrelated, If you like instrumental relaxational music good for studying, meditation, yoga, sleeping, chilling, etc, check out my music, also all for free, on Spotify or my website (same as my user name).