DC Coupler DR-DC10 (Battery To DC Canon SX 160 IS) by trustfm

Last crawled date: 3 years ago

This DC Coupler replaces the battery pack in the Canon camera body and allows it to connect to an AC adapter.
I do not have any responsibility if you damage your camera
Compatibility
-- PowerShot A1300 Black
-- PowerShot A800 Red
-- PowerShot A800 Black
-- PowerShot A810 Red
-- PowerShot A800 Silver
-- PowerShot A810 Black
-- PowerShot A800 Black Refurbished
-- RFDSX160ISBK
-- PowerShot SX150 IS Black Refurbished
-- PowerShot A810 Silver
-- RFDSX150ISRE
-- PowerShot A1300 Silver
-- PowerShot SX160 IS Black
-- PowerShot SX160 IS Red
-- PowerShot SX150 IS Red Refurbished
-- PowerShot SX150 IS Black Refurbished
-- PowerShot A810 Red Refurbished
-- PowerShot SX160 IS Red Refurbished
-- PowerShot A1400 Refurbished
-- PowerShot A1400
-- PowerShot A800 Red Refurbished
-- PowerShot SX160 IS Red Refurbished
-- PowerShot SX150 IS Red
-- PowerShot SX160 IS Black Refurbished
-- PowerShot SX150 IS Black
-- PowerShot A800 Silver Refurbished
-- PowerShot A810 Black Refurbished
-- PowerShot A810 Silver Refurbished
I have tested it with the PowerShot SX160IS Black
You have to solder two wires (28awg 2 pin black / red wire was used) and a DC jack in order to complete the project.
The RED(+) wire is located at the cylinder with the outer slot.
The BLACK(-) wire goes into the cilinder with the one internal lateral slot.
I have used PLA in order to print this object .
No glue is needed for this project just use a small wire and use solder.
You should use a DC 3V 1A Power supply
I do not have any responsibility if you damage your camera