DartZone Pro Mk2 speed loader by printamonium

Last crawled date: 2 years, 10 months ago

Speed loader for the DZP Mk2, if you can't order more or want to print your own.
Instead of a spring, there are notches along the middle. The front and rear plates help to hold the prongs in just enough that the pusher can move freely but still catch at each level (may need a bit of zipping back and forth several times before it becomes smoother.
The magnets aren't completely necessary - it will still work, just the pusher might need holding on to when you're loading. If you'd like to use it with magnets, you'll need to get 8x3mm circular magnets. The vertical slots are where the magnets should go, the holes on the very bottom are for mounting on my body kit so as a standalone it's not necessary to put magnets in here.
Ideally you'll want supports at the very top. If your print cooling is really good it is possible to print without it.
Now with 12 dart capacity version! Hasn't actually been tested yet though but theoretically should still work?