Cut Parts for a Prusa Mk3

Last crawled date: 4 years, 2 months ago

These are the files I created to help print the mercy staff parts on my Prusa Mk3. Most of them are too tall for the printer. The Handle is in two parts with some pins. The Wing is in two parts with some hexagon pins. The battery holder is for inside the pole. The Foot is modified to assist in screwing the parts to each other.
The battery holder might be too snug a fit so maybe drop the print % down a notch or sand a lot.
LED Base are what i used to mount the LEDs inside the polycarbonate rod. The leds I used were 3mm wide angle LEDs I purchased from LEDLighthouse.com. Note this is an extremely tight fit for the lights and will require some halfway decent soldering skills. The extra holes in the circle are to run wires through and onto other sets of leds and to the batteries.