Customizable Round Pipe Cap with Hanging hole (fusion360) by asimomagic

Last crawled date: 2 years, 12 months ago

This is a pipe cap with hanging hole. It can handle various pipe diameters.
Customization is done by changing the parameters of fusion360 file (.f3d).
[Features]
-Customizable
-Fixed firmly
-Hard to break even if squeezed strongly with a wrench
-Easy to remove from the pipe
-Easy to print(no support)
[Design point]
Designed so that when the bolt is tightened, the bolt is parallel to the pipe. This enabled stable tightening.
[Bolt/Nut type to use]
type: CAP bolt and Nut M3 - M6
bolt length: The needed screw length is approximately equal to or greater than the pipe diameter.
[Customizable parameters]
-Inner diameter of pipe (min:10mm at M4, max: no limit)
-Outer diameter of pipe
-screw size (M3, M4 ,M5, M6 )
screws larger than M6 are also possible by manually setting the screw related parameters. (set "bolt_d", "bolt_hd", "nut_w", "nut_h". You need not change "ss")
-Top hole presence or absence
[caution]
-The hole for the nut is designed tight. Completely remove any residue remaining in the holes. I think the fastest way to insert a nut into a hole is to use pliers.
-Since the input value of the parameter is not verified in the fusion360, an error may occur. For example if you use a too large bolt for a small inner diameter pipe, it may break. ex. M4 to 9mm pipe.
If an error occurs, click the OK button in the parameter change window, and then click the undo button to return.