Cr10s-pro breakout board + filament sensor + cable chain mod (Crusa mod)

Last crawled date: 4 years, 2 months ago

Third part of my Crusa mod to go with the MK3s extruder on the Cr10s Pro.
Find my Mk3s adapter here: https://www.thingiverse.com/thing:4151703
I rearranged the breakout board for easier access, with a hinged door for protection.
In the same time I added the attachment for proper cable chain management on the X and Z. For the Z I bought new 30pin flat cable, you need about 50in /1.3m of it and new female plugs, it was a pretty easy process to split the flat cable every five and then tape stack it to fit in the cable chain as you can see in the pictures.
The cable chain used is a 10x10: https://www.amazon.com/gp/product/B07WDVJB8W/ref=ppx_yo_dt_b_asin_title_o00_s02?ie=UTF8&psc=1
I also reworked the filament sensor with the same inside as the Prusa Mk3 using a steel ball for easy insertion. The switch is the original one. If you want your filament sensor in a different place you can just skip its base and cover. After printing the sensor base, you need to get a 2mm drill thru the top hole to clean it up.
That new filament sensor setup also feature a reverse bowden attachment using an M6 connector as you can see in the pictures.
Most of the hardware is the original Cr10s pro with a few more M3 screws.
Let me know if you do it and if you have questions ;)