Coffee Cup Christmas Ornament by bpmarkowitz

Last crawled date: 3 years ago

(UPDATE: added a cup + lid in one part combo since I had some request for it. It has a little cutout in the bottom so you can tie off the loop for the hanger w/o it showing. Print with 20% infill)
This ornament, while not technically a remix, was inspired by another coffee cup Christmas ornament here on Thingiverse, so I want to give that thing a shout out.
Designed from scratch, this is slightly different in that it prints in three parts. This allows the cup to be hollow, and therefore prints much faster (and lighter). Also, it has a printable insulator ring. When you combine materials it can make for a very cool ornament.
Print Settings:

Cup and insulator: print at a .4mm wall with 0 infill. This leaves them hollow, but makes for a very fast and sturdy print. I've printed w/ and w/o rafts, ymmv. Layer height up to you.

Lid: print at 1.2mm wall thickness, 20% infill. Layer height up to you.
Post Processing:

All parts should snap together fairly sturdily, you may wish to add some glue for more stability, but most likely not needed.

Add a string through the hole and knot, you may wish to use the included washer to tie your string to so it can't pull through!
Please post your make!