Christmas Tree Star by psdesign

Last crawled date: 3 years ago

This is similar to many others out there, but I created this from scratch so you can print both halves easily.
I add custom support only under the edges of Christmas StarTop.stl.
The rest prints without support.
The two halves should fit together nicely and you can use the christmas star spine (print 2 of these) to align during assembly.
I bought this battery controlled light string:https://www.amazon.com/gp/product/B00QGVET18/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1
cut them down a bit and hot glued in a clean array inside the body.
I left the battery box hanging out so you can turn off and on.
I printed all parts at 130% as the original was a bit small.
if you make one of these please post your photos on this page.
thanks!