Chevrolet K5 Blazer body for Axial SCX24 by KristianK5

Last crawled date: 3 years, 3 months ago

Chevrolet K5 Blazer hardbody with removable roof that is made for Axial SCX24 Deadbolt.
The body, roof, grille and bumpers are remixed from:https://www.thingiverse.com/thing:2875250
NOTE: This is not "bolt on". Test the fitment before gluing on the bodymounts. The model could be made 5mm longer to fit the deadbolt chassis better.
To mount it to the SCX24:
Remove the rear body hinge from the original body and chassis, flipp it around 180 degrees and glue it to the bottom of the printed model all the way back to where the floor drops, then screw it back on the chassis (In the picture RearMount_2 there is a small gap between the mount and the floor drop, that is not necessary).
The front mount is glued to the front body posts and under the hood of the model and attaches to each other with magnets.
Magnets for front mount x 4:
Block magnet 10 x 4 x 2 mm
The roof is also monted using magnets.
Magnets for roof mount x 8:
Block magnet 20 x 3 x 2 mm
The bumpers, seats, grille, dash, mirrors and taillights are glued on after paint.
Some of the parts may requre some sanding because of a tight fit.
Since Thingiverse won't let me list more than one remix Source File i will list the rest here:
Dash and steering wheel: https://www.thingiverse.com/thing:2702182
Mirror: https://www.thingiverse.com/thing:2575750
Front seat: https://www.thingiverse.com/thing:2994278
Bench: https://www.thingiverse.com/thing:4056459