Ceres Galliot MicroQuad 110mm by DwarfStarFPV

Last crawled date: 3 years ago

UPDATE: NEW FPV FRAME FOR 8.5MM MOTORS AVAILABLE, WITH EASIER WIRE ROUTING
I bring to you the Ceres Galliot 110mm Microquad.
Designed with the original Ceres Galliot from Destiny in mind I modeled the arms to have almost the same detail as the original.
This Quad is capable of holding a Micro Scisky FC, a 600TVL camera and the TX (FX-758-2) all in the frame, my scale is broken so I couldn't measure the body to see how much it weighs but when my new scale comes in I will but according to the program the top should weigh about 3.63g and the frame weighs 12.29g.
Support will be needed for top and frame, if you have simplify3d I can send you the support file I used to get everything to print perfect, just comment.
You have 2 options for this Quad, 8mm motors or 7mm motors also FPV or No FPV then you can use a 3mm LED for the LED top, you will need two tiny screws to hold the top to the frame, it does clip in but if you crash the top will fall off so get some tiny screws around 1.5mm diameter and they will hold on great.
I hit this quad into the wall about 20 times printed with a soft PLA and no cracks or brakes, so if this was printed in ABS it would hold up against some big crashes. It was very stable when i flew with the Hubsanx4 FC Board so imagine how it would fly with a Micro Scisky or Micro MWC FC Board.
Here are links to the parts i built this Microquad around
FC- http://www.banggood.com/Micro-Scisky-32bits-Brushed-Flight Controller
VTX- http://www.banggood.com/FPV-5_8G-200mW-32CH-Wireless-Audio-Video-AV-Transmitter-Module-FX758-2-p-980317.html
Camera- http://www.banggood.com/600TVL-8_0MP-14-2_8mm-CMOS-FPV-170-Degree-Wide-Anlge-Lens-Camera-PALNTSC-p-984345.html
Props- http://www.banggood.com/H108C-31A-3-Leaf-Blade-Propeller-for-HubsanX4-JJRC-H108C-H6C-CX-30-p-970931.html
Print it Fly it and have fun, leave your comments about any flaws and I'll try my best to fix them :)