CERAMBOT-Effector

...r anycubic kossel thingiverse cerambot extruder mount for anycubic kossel just print and mount in the existing fisheye effector.

...cerambot procontrollerpcb housing thingiverse model for the cerambot procontrollerpcb

...cerambot - limit switch block thingiverse cerambot - limit switch block

...cerambot lcd housing thingiverse control panel housing and face for cerambot printer

...brecket and turn knob for cerambot thingiverse a brecket for mounting the control panel and a turn knob for cerambot

...cerambot　endcapspacer thingiverse this part may be useful if you want to put a flat board on top of the cerambot.

...cerambot pro extruder spacer thingiverse spacer for cerambot pro extruder you can keep the tank vertical.

...rse i made it because it became unstable when i attached rubber feet to the cerambot. spacers are not required for endcaps only.

... the cerambot. just use the original display to mount it. you can use m3x30 screws to fix the display to the holes. (see picture)

... thing 3196872 ** this is not a functioning extruder, just a dimensionally accurate model that is used to build extruder holders.

...cerambot　endcapspacer thingiverse this part may be useful if you want to put a flat board on top of the cerambot.

...cerambot procontrollerpcb housing thingiverse model for the cerambot procontrollerpcb

...cerambot lcd housing thingiverse control panel housing and face for cerambot printer

...cerambot - limit switch block thingiverse cerambot - limit switch block

...brecket and turn knob for cerambot thingiverse a brecket for mounting the control panel and a turn knob for cerambot

...rse i made it because it became unstable when i attached rubber feet to the cerambot. spacers are not required for endcaps only.

...cerambot pro extruder spacer thingiverse spacer for cerambot pro extruder you can keep the tank vertical.

...ut, contains content: m6 screw length: 280mm2 m6 thumb nut2 m6 thin nut2 304 stainless steel flange1 https://youtu.be/oiyorpdjqo4

...r anycubic kossel thingiverse cerambot extruder mount for anycubic kossel just print and mount in the existing fisheye effector.

...e spheres will expand with your song. fully customisable, change the color, the size of the spheres or even put in different s...

...mograph compatible (you can effect the pieces with mograph effector) - included also a non-mograph version with...

...effector by olo2000pm thingiverse effector

...ulize effector by candyasdf thingiverse mount things on effector with m3 screws effector radius : 25.4mm rod arm distance : 40mm

...delta effector by zavier thingiverse delta effector with radial fan 50 and bltouch

...d810 effector by whitetiger13 thingiverse this is d810 effector for d810 without autocalibration, and also cap for it.

...effector for delta printer thingiverse effector for delta printer (3 color) using diamond hotend

...delta effector magnetic by fpassos thingiverse effector for e3dv6 hotend. i needed put the spheres (10mm) on the effector.

...end effector gripper thingiverse end effector gripper for a robotic arm uses mg995 servo motor