Ceiling Fan Chain Pull Knobs Collection by ShaneAPowell

Last crawled date: 3 years, 1 month ago

I created a Batman ceiling fan chain pull knob for my oldest daughter. The next thing I knew, my other kids wanted their own fan chain knobs. Then, the neighbor kids. Then my daughters friends.... so.. the requests started pouring in. This is the collection of all the fan pull knobs.
Yes.. these are nothing more than a collection of existing "Things" from around Thingiverse. I just grabbed them, remixed a hole into them and voila!

Batman
res: 0.1; walls: 2; 20% infill.
No Supports.
Easy to print


Snoopy
res: 0.1; walls: 2; 20% infill.
Supports.
Easy to print, supports not too hard to remove.


Shark
res: 0.1; walls: 2; 20% infill.
Supports & Brim.
Hard to print, supports hard to remove, tail is fragile.


Ghost
res: 0.1; walls: 2; 20% infill.
No Supports, Skirt
z-hop enabled.
Moderate Print. Good build plate adhesion needed if using Skirt.


Darth Vader
res: 0.1; walls: 2; 20% infill.
No Supports, Skirt
Easy Print


Pac Man
res: 0.1; walls: 2; 20% infill.
No Supports, Brim
Easy Print


Storm Trooper
res: 0.1; walls: 2; 20% infill
No Supports, Brim
Easy Print


Minion Bob
res: 0.1; walls: 2; 20% infill
No Supports, Brim
Easy Print. Printed upside-down with supports only on build-plate. I tried another

Turd Emoji
res: 0.1; Walls 2; 20% infill
No Supports, Skirt
Easy Print.

P.S. This project is a non-stop-work-in-progress since I'm going to be non-stop-adding-new-pulls to it, and adjusting the sizes and hole diameters on existing ones..