Cantilever Suspension for Axial SCX10 by RMTCTRL

Last crawled date: 3 years, 1 month ago

I made this Cantilever Suspension to remove the rear shock towers so you can have more options for bodies on you Axial SCX-10.
My Main goal was to use the stock shocks to keep the cost down. You will need to print the parts and purchase a couple nuts and bolts. But overall cost is really inexpensive. Plus if anything breaks you can always print a new part!
Here is a list of parts that are needed to complete this project.
Printed Parts:
1 x Base (Added a second base option with larger peg holes for the "Mount Left and Right" if you print is too tight)
1 x Mount Left - Glue to "Base" part
1 x Mount Right - Glue to "Base" part
2 x Pivot 1
2 x Pivot 2
2 x Spacer 1
2 x Spacer 2
Bought Parts:
2 x M3 40mm bolt
2 x M3 nut
4 x M2 16mm bolt
4 x M2 nut
(you can use M3 bolts and nuts instead of M2, you just need to drill the holes a little bigger)
Bought or made Part:
2 x Push rods 28mm long from center of ball joint to center of ball joint
--- For the Push rod (the connection between the cantilever itself to the axle), I used the extra rod ends that you get when you buy a SCX10