Calibration Tools by BSkorn

Last crawled date: 3 years ago

These are some of the models I use to setup/calibrate my 3D printer.
Below is a list of what tests are being performed when printing models.
Model No.1 and No.2
-Bed level and Flatness
-Z Axis Probe Offset (if **Z Axis Babystepping enabled**, adjustment can be made
while printing)
Model No.3
Please scale model by **250%** and set infil to **95%** in slicer.
-Extruder e-steps
-Filament Nozzle Temperature
Model No.4 and No.5
-X and Y Linear accuracy (Mechanical Adjust or slicer XY compensation)
-XY Squareness Accuracy (Mechanical Adjust)
-XZ Squareness Accuracy (Mechanical Adjust)
-YZ Squareness Accuracy (Mechanical Adjust)
I always like to re run the extruder e-steps calibration again just to confirm that everything is still correct after adjusting the linears and squareness.
Then print a couple of different models like benchy, frog, gear bearing etc. If it gets thought all of the above your printers volumetric and linear accuracy should be good