Breast Pump Hanging Rack for Pump Parts by sjgittins

Last crawled date: 3 years, 4 months ago

Wife's pump parts are top heavy and fall over all the time in the cabinet, then pour down onto the counter and sleep deprivation makes us all mad. This allows the pump parts when fully assembled to hang from the bottom of the upper shelf, freeing up space and preventing them from falling over constantly. Didn't fix the marriage though, so don't get your hopes up.
Depending on the depth of your cabinet, just stretch the Z in your slicer to fit. Or, in my case, I printed 2, but only part of the second one since my cabinet depth was over 10 inches and this part is just shy of 8 inches.
Print vertical, and pay CLOSE attention, there is rounding and 2 small catches to stop the parts from sliding out the front, so make sure you print this rounded edge section on top. I used a brim to print, but only on half of the prints and they still came out fine. Printing PLA at 50mm/sec speed on Ender 3 pro.