Boeing 737 MCP Korry-like switch for simulators by Merikarhu

Last crawled date: 3 years ago

I have been modeling this part for long time and my plans have changed a lot from where i started.
Print both pieces separately and attach tactile switch on the case (it only goes one way). And try to push korry button to it
I'm using these switches (tactile 12x12x8mm) without caphttps://www.ebay.com/itm/20pcs-Momentary-Tact-Tactile-Push-Button-Switch-12-x-12mm-x-8mm-4-Pin-DIP-w-Cap/321057620566?hash=item4ac0868256:g:A9AAAOSwBjdaOSPD
You can also attach 2mm square leds to button and wire them with jst style connectors.
Printing needs some support, but not too much if you like to have quality.
Print with best quality as possible.
Update 28.1.2018
Added collar for better connection for the MCP backpanel
Rounded corners
Internal size now 17mm and outer 21mm
Reduced tactile insertion window
Update 21.1.2018
Cleaned Casing model for better print quality
Update 18.1.2018
Down scaled button a little bit
Increased size of led holes
Removed unnecessary clips on the casing and button as tactile switch has enough holding power
Increased width of casing bottom