Bloodhound Mask helmet and other bits WIP v1.0

Last crawled date: 4 years, 3 months ago

Everything here so far is what i've used to build my Bloodhound cosplay , I'm probably only half way finished building him as it's a lot of detail to be added.
To do:
-Upload the rest of the stencil pattern helmet pieces that glue around the helmet.
-How i done the shoulders and straps / Stomach metal plates
-Install a led ring set into the eyes to go bright red
-More to add
Current info:

Bmx skate helmet L :https://www.ebay.co.uk/itm/PedalPro-Kids-Adult-Gloss-BMX-Skate-Safety-Helmet-Bike-Bicycle-Cycle-Scooter/332671207150


Metal ring clamp lense removed from Gp-5 gas mask , measures to 70mm Diameter


2x 3mm Acrylic smoke tinted lenses from ebay:https://www.ebay.co.uk/itm/Laser-Cut-Plastic-Circles-Acrylic-Discs-Perspex-3mm-5mm-Black-Tint-Transparent/142823852789


Tidy cable tubing /non split, 16.9mm internal diameter :https://www.ebay.co.uk/itm/Conduit-Split-Non-Split-Tube-Cable-Tidy-Corrugated-Flexible-Loom-Trunking/322186760456
(Made a foam cork to fit inside and screwed into from inside the mask)


Normal 6mm black wire with solder wrapped tightly around base
Bent wire into a circle inside and glued into place

Pepakura files were used with Eva floor foam in mind and scaled to fit a 5'11ft Person.
I Bolted in 2 places to hold the top head dress down to the skate helmet.
Also removed the entire foam insert but it may differ per person.
You will need to drill holes for the capsule so that you can breathe.
I can also upload the ski mask pattern if needed