GrabCAD
BlackSlim01
by GrabCAD
Last crawled date: 1 year, 11 months ago
BlackSlim01, compact size 57.6 x 87.5 x 13.5 (mm), it can be wall mounted or just stand on table with rotating the pads below the wall mounter.
I made a little change in the PCB. It has 5 different colors and a special Black Edition.
The design is simple because it only needs 2 buttons, power button and sleep button. You can use the sleep button when transferring via Bluetooth and want to save battery, so the lamp will turn off and it'll just on again when finish.
It has 3 different color lamps, when power button pressed it'll turn green, when transferring or reading it'll dim green and the speaker will bip once when succeed, if fail the speaker will bip twice and the lamp turn red. The lamp turn dim red when low battery, turn dim blue when charging and blue (not dim) when battery full.
I design it as simple as it can but still lux and compact. Thank you
Rev01 : add mag strip reader slot at top of side case :)
I made a little change in the PCB. It has 5 different colors and a special Black Edition.
The design is simple because it only needs 2 buttons, power button and sleep button. You can use the sleep button when transferring via Bluetooth and want to save battery, so the lamp will turn off and it'll just on again when finish.
It has 3 different color lamps, when power button pressed it'll turn green, when transferring or reading it'll dim green and the speaker will bip once when succeed, if fail the speaker will bip twice and the lamp turn red. The lamp turn dim red when low battery, turn dim blue when charging and blue (not dim) when battery full.
I design it as simple as it can but still lux and compact. Thank you
Rev01 : add mag strip reader slot at top of side case :)
Similar models
grabcad
free
easy_pay
...ction is success, a blue led lights up.
-will turn on a green/red led in the middle, according to payment accepted or rejected.
grabcad
free
easy_pay_K
... created a circular base that can rotate the device.
ithe assembly of the base and the substrate, are very simple.
best regard!
grabcad
free
magstripereader x-power
...corner is for battery, on the bottom left-right corner are led's for power and sleep mode. it can be wall mounted if u want!
grabcad
free
The Angle new
...with stand part,
and the device connect to the stand part with "ball locked system"
thats all
thanks
^_^
muchlis eko
cg_trader
$5
Mug of Three Colors | 3D
...icize, i'll listen to everything and in the future i will do better. here 3 circles of different colors are green, blue, red.
grabcad
free
Blackboard Transact
...interpretation error, where i did not see that the device needs to have mag strip reader and i developed only for nfc technology.
grabcad
free
G&J Reader Device
...this is an effective design that has a clean and aesthetic look that promises to be a perfect fit for a professional environment.
grabcad
free
Blackboard TRi-angle
... blinking orange led means replace battery.
on the top of the reader device is a card reader slot.
i hope you like this design.
grabcad
free
Mobile Reader Device Challenge
...d in 3d but one of the other ways to produce it would be by injection molding.
technical drawings will be uploaded when needed.
grabcad
free
NFC/Mag Reader (Blackboard)
...an alarm in case its rejected. the dock has similar characteristics to the reader itself making it able to...