BCN3D Sigma Z-Spacer by makeasec

Last crawled date: 3 years ago

Z spacer to account for the offset between nozzles with duplication mode on a BCN3D Sigma.
Exported at 1 mm height - just scale it on Z to account for your offset, print solid.
To get the offset run a full calibration (unless you have just recently) and execute M503 to read the offsets afterwards.M530 has the Z offset for the left nozzle to print the spacer with.
Up to .1 mm is easier compensated with slightly fastening the nuts and does not require a spacer.
See BCN3D's wiki on Github for instructions on the duplication modes available and how to set up each.