Thingiverse
Battery charger for CRC123A RC123A using TP4056 module by cmag16
by Thingiverse
Last crawled date: 4 years, 3 months ago
Here is a charger for CRC123A/RC123A batteries, using a TP4056 charging module.
I'd printed other models but found them too tight to place/remove the cells, so I designed this, giving more clearance and using springs salvaged from an 18650 module. The module and springs were hot glued.
I stripped the wire to fit through the holes, just to make it more compact and keep the wire flush to the bottom.
I'd printed other models but found them too tight to place/remove the cells, so I designed this, giving more clearance and using springs salvaged from an 18650 module. The module and springs were hot glued.
I stripped the wire to fit through the holes, just to make it more compact and keep the wire flush to the bottom.