Barbell Lock

...re's a cap to be glued onto the top of the when assembled. if there's enough interest i'll look into a printed hinge.

...barbell clip by kintall thingiverse barbell clip! it's a clip... for barbells!

...oercstar thingiverse created this cover for my barbell prefents to scratch the floor outer edges stops the barbell from rolling

...clamp for barbell or other things by roger1008 thingiverse clamp for barbell, crosfit

...best coach barbell plate thingiverse best coach barbell plate.

...barbell holder by socialbit thingiverse keeps your barbell right in place.

...barbell handle thingiverse extension for barbells, making a handle on it's sides

...clamp for barbell or other things by roger1008 thingiverse simple clamp for a barbell or other things

...barbell, dumbbell keyring by nikki73 thingiverse just a simple weights keyring. barbell / dumbell :)

...barbell by notajoke thingiverse this is a 45 lb barbell which goes with the weight lifting bar.

...barbell handle thingiverse extension for barbells, making a handle on it's sides

...barbell clip by kintall thingiverse barbell clip! it's a clip... for barbells!

...barbell by notajoke thingiverse this is a 45 lb barbell which goes with the weight lifting bar.

...barbell by meltzner thingiverse finger barbell for those working on pinky strength. recommended print with supports and a brim.

...oercstar thingiverse created this cover for my barbell prefents to scratch the floor outer edges stops the barbell from rolling

...barbell holder by socialbit thingiverse keeps your barbell right in place.

... perfectly with york, bollinger and cap barbell weight sets. what else can i say, it's pretty straight forward and simple! :)

...best coach barbell plate thingiverse best coach barbell plate.

...e this is a two-piece barbell holder. i used felt pads to protect the floor. the diameter of the weights in the picture is 15cm.

...caps lock lock by fx137 thingiverse mechanical lock for the caps lock key suitable for the corsair vengenace k70

...door lock (box lock) by manunam thingiverse i made this lock for my tool box

...that holds the u lock on the bike seatpost. i've removed the bolt and nut housing beacause they are useless and hard to print

...servo lock thingiverse servo lock

...lock by bobjrbob thingiverse a cool lock

...beyblade lock thingiverse infinity lock beyblade

...lock by alfredkim74 thingiverse desigm of an ergonomic and anthropometric lock

...lock by lilchamp thingiverse its a lock with my initials in the back

...beer lock with 6mm lock hole by ruben_zilzer_3409 thingiverse same disign as bkahuna but for a bigger lock by