Barbell Collar by freemasen

Last crawled date: 3 years, 4 months ago

This is an update to the very well put together https://www.thingiverse.com/thing:3655644 which perfectly fits an Olympic barbell (that is a ~50mm or 2" diameter).
First, the "base" with towers has a short fat pin on the end, this was slicing incorrectly as two parts, meaning it would break off very easily, I've updated it to be fully integrated.
The other changes I made were to flatten both the "pivot connector" and the "lever", these parts still need some supports for the actual joint but now the body of each should not require nearly as much. Because I've adjusted the "lever", the "side grip snap" is no longer compatible, however I have found it is not actually required to get a good grip on the bar.
The full print list is as follows
2x Base No Towers
2x Base Towers
2x Side Grip
1x Lever
1x Pivot Connector
1x Spacer
1x Pin