Banana and XT60 - Splitter box by 3DBullett

Last crawled date: 3 years ago

Hello,
sometimes you need more than One.
The banana box shares 5 plugs from any source you want. Also left a hole for an outgoing cable to "the next splitter".
And while i like the XT 60 connectors, here also a XT60 splitter with support inside the box and a "fixing" screw to hold the connectors in place. Not a 100% needed screw cause the soldered cable prevent the XT60 connector of been pulled out of the box.
The screws for the covers, on both boxes are M4.
The holes in the boxes going by to the top surface of the bottom, so you can use any lengh , limit by the height of the box :) (is it to understand?)
The screws to blockade the XT60 connectors are M3.
Banana Box Holes: 8mm diameter. if you need different, write in comments
If you need a modified or smaller / bigger box. Contact me!
If you need a box for a different type if connector. Contact me!
See also my other designs, especially the torture / stress egg: https://www.thingiverse.com/thing:3072772
Thanks for following
3D Bullett