Arstid Ikea Lampshade by quakeman0

Last crawled date: 3 years, 1 month ago

41.8mm diameter of hole for the 40mm socket to go through and then you tighten on the fastener for the socket and screw in your bulb through the 100mm hole on the top.
I printed on my 0.8mm nozzle Cr10 using white PLA at 0.2mm layer height and 33% concentric infill, one wall, and an alternating wall setting in Cura is applied, it should use 240g of filament. Should be printable without supports, just keep an eye on layer height and overhangs it creates if not using 0.2mm layers. The brass colour top I just made by cutting my white PLA and triggering a filament change detection replaced the white with copper hatchbox PLA and carried on from there at 196ish mm height.
Solutech PLA "Real White" 1.75mm
Special thanks to Taylor Stein from the Fusion 360 Staff on Youtube for this wonderful guide: https://www.youtube.com/watch?v=3PnKBSOulwo