Armattan Morphite 10 degree motors mounts by linklemming

Last crawled date: 3 years ago

10 degree 1306 motor mounts for the Armattan Morphite
Use 2 for each motor mount, its a little bit of a puzzle but you will figure it out.
You will need to enlarge the screw holes a tad depending on how accurate your printer can produce holes. I used a pin vise and reamer.
You will need to enlarge the holes on your morphite frame to allow the bolts to be at a 10 degree angle. I used a needle file.
These came out at 9.3mm on my printer. I used m2x12mm socket head bolts and washers. Be careful not to damage your motors by using bolts that extend into the motor too much.