Arduino Uno case w/ reset switch by Scofferoff

Last crawled date: 2 years, 10 months ago

Arduino Uno case with a reset switch.
Wire routing is done sideways. I use the 90 degree pins, makes them more stackable.
Top & Bottom vents to prevent overheating from the monumental processing power of the Uno! might need a fan too?!
Insert the reset switch post in the Top from the inside before assembling Top and Bottom.. It might work best doing this upside down ... You can be the correct way up though.
And don't forget to populate the headers with 90 degree male pins too.
For a finished project you can point one side of pins inward and have all wires exit on just one side, it there's room. OR just drill a hole in the rear for the wires and have all pins facing inward for a very clean Inline appearance.
.
I built this more to be a stylish Coffin for the Uno since discovering the ESP32