Arduino Sensor Shield V5.0 Case

Last crawled date: 4 years, 3 months ago

This case is used for protect the Arduino + Sensor Shield V5.0
To assemble the parts, you will need a M3 pipe tap and the following screws:
M3 x 5mm 3pcs for mounting the Arduino boards
M3 x 25mm 4pcs
M3 Hex Nuts 8pcs (optional 4 pcs)
Fixing the Arduino board with the 3pcs of M3x5mm screws and hex nuts, from bottom side, before you mount the sensor shield board.
The upper cover and lower base case can be screwed together without the hex nuts by only the M3 threads. But you can mount 4 hex nuts on the bottom side to enhance the strength.
To print the reset button, you have to slow down the print speed with fastest cooling fan, when the diameter of the button cylinder is only 3.8mm