adjustable multi voltage power box for the stacker and trommel by caj

Last crawled date: 3 years, 1 month ago

voltage list
water pump 12v marine water pump
stacker runs best about 6v
shaker motors and shaker drum run best at about 3v
parts list
1/2 in screws for plastic
2 buck LM2596 DC-DC converter
4 push button on off switch
10 sets Power Jack Plug 2 Pin Wire & Socket Connectorhttps://www.ebay.com/itm/Lot-of-20-Power-Jack-Plug-2-Pin-Wire-Socket-Connector-Lead-22-AWG-300V/321824105800?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
the bus block
strip 2 pieces of wire about 28mm and tin then insert into the short side of the block and use grub screws to tighten one end to keep them in place if you do not have grub screws then use the 1/2in screws for plastic i have made this block to accommodate these screws this is what i used i do have grub screws but did not want to waste them on these bus blocks
make a bus block for the trommel and stacker for the cable extensions to the power box
the extension wires from the power to box and box to trommel and box to water pump I assume you can figure out how to make
there is a picture of the bottom i hope you can see the wires i tried to keep it as clean as possible
basically all the ground wires go to the ground side of the bus strip
ground in goes to bus ground side
plus in goes to main switch then other side of switch goes to bus plus side
then wire red from the plus side to each switch and the other side of the switch to +in
then wire ground from the ground side of the bus to each buck DC-DC -in
12v switched out run plus side of strip to 12v switch and the other side to +12v lead out
solder the other 2 out plugs directly to the buck DC-DC converter -out and +out