Adapter 2 inch (ocular side) to 1,25 inch (telescope side) by apos22

Last crawled date: 3 years, 1 month ago

Telscope Adapter 2 inch to 1,25 inch
For usage with my 2 inch barlow on my 1,25 inch telescope focuser ;-) Something you would not get very easy to buy.
Print
Rotate, so the 2 inch side is on the bottom. I used a little bit of sandpaper to get the 1,25 side to fit well.
Printed in ASA: I experimented with resizing. I got good results at 101.5 percent. This may vary from material to material and printer to printer.
Test print
Make a test print on the 1,25 inch side IN ANY CASE. Therefore use the test print circle (use a brim) ;-) Check, if the result is OK for the focuser.
Remember: you alway could print a little big bigger and remove material with sand paper, but not the other way round ;-)