8mm legolini conversion and miscalanious stuff by Mad_Maximus

Last crawled date: 3 years, 4 months ago

NEW: i atempted to use a fully 3d printer arrow(it failed) so i made this design which uses 5mm shashlik pins to connect the carbon shaft to the 3d printed vains and knok to make the pin larger to fit inside of the carbon shaft i used archery nylon(or whatever this stuff is)string wraped it around in one layer and glued it in place so far these arrows work even better than my more makeshift ones and are more accurate
i remixed the bow to be for 7.5mm shafts now it can hold 6 arrows instead of 7 (i think didn't print the 6mm original and dont have those arrows). the purpose was to be able to use old broken arrows from bows and cut them to size(i succeded and all of my arrows are recycled.
optimised mainly for 0.6mm nozzle should still print fine on 0.4 jst without the TIGHT fit which required me to file quite a bit
knok fits perfect with 0.6mm nozzle might need to take it to tinkercad and make the inner cylinder larger by 0.2mmish
the stripper clips work ok and hold on fine but need to be fitted in order to work. adding some elctrical tape to lose sections of the clip can improve retention of arrows. to make the clips better hold it closed and slightly melt the top of the arc to create more pressure on the arrows it worked nicely for me
the mag remix needs some sanding to fit the arrows and to run smooth the barrel is a remix of https://www.thingiverse.com/peters1/designs design
i had to split his mag to be printable on my machine like the original legolini
since these arrows are larger and heavier they have more drop and lower velocity but it still works fine and is stupid fun to shoot