6DOF Robot arm by ThatNewMaker_101

Last crawled date: 3 years ago

This is my first thing to upload so sorry if instructions are bad.
You need 6 servos for this.
1.First screw the 2 bases together using M3 screws and nuts.
2.Mount the servo mount and then screw in the servo with M4 screws and nuts.
3.Mount a bearing on the back side of the servo through the hole, then an attachment to the teeth upfront. Secure it to the servo using an M3 screw.
4.Mount a bracket to the servo with M3 screws and nuts.
5.Mount another bracket on the previous one also with M3 screws and nuts.
6.Mount the servo mount and then screw in the servo with M4 screws and nuts.
7.Mount the smaller bracket (short side out) on the bottom of the servo mount with M3
screws and nuts.
8.Attach the last bracket to the short side of the smaller one with M3 screws and nuts.
9.Mount the servo mount on the bracket and then screw in the servo with M4 screws and nuts.
Attach the gripper to the last servo with M3 screws and nuts.