3Dlabprint spitfire landing gear by donandtheresa

Last crawled date: 3 years ago

Added the tail wheel block to attach it to the spitfire. Just been busy and haven't had time to sit down and finish all of it. The pictures look rough as I just rushed thru to cut the hole in the fuse, but you can get the idea on how its suppose to fit. I think the servo block I made for the mustang will work for this too but I have not tested that. Would be easy for you to make your own servo holder also. When I get more time I will finish what I started and put all the files on here. Mustang landing gear will be revamped also.
.I made landing gear for the 3dlabprint P51 but they were flimsy. I made these for the spitfire and if they prove better I will remake the P51 landing gear the same style. As of now its just the fronts, I will add the tail wheel assembly later.
I used 3mm wire for the actual gear and epoxied them into the actually strut.
PLA that matched the plane.
Layers top:3 Bottom:3 outline:2
10 - 20% infill.
Once assembles I epoxied them on the bottom of the wing where the first joint was for added support.