3Ball Fidget Spinner by OmarKhatib

Last crawled date: 3 years, 1 month ago

My first fidget spinner design. Uses a standard 608ZZ bearing in the middle and (3) 1/2" bearing ball on the outside ends. The center bearing slips in one side. Push in until it hits the ridge on the other. The caps (3BallHolder01.stl) push in on either side. You will need 2. The 3 bearing balls snap in on each end.
Center Bearinghttp://www.vxb.com/Fidget-Hand-Spinners-s/1593.htm
1/2" Bearing ballshttp://www.vxb.com/0-5-Inch-s/1170.htm

Hatchbox Filamenthttps://maninbox.biz/collections/frontpage
Of coarse you can find them on Amazon too.