1/6 Scale RC Stand (3 Versions)

Last crawled date: 4 years, 2 months ago

Large Scale R/C Truck Stand I built for my Losi Super Baja Rey.
100% Printed
All Pieces have been uploaded
Let me know if you have any issues.
Some thumbnails are not showing for some of the STL files.
Thingiverse has a lot of bugs.
I have uploaded new versions of the Center and Saddle Arm.
Version 2 of these two things are larger than version 1.
The arm are longer and beefier
Version 1 worked fine but I wanted a longer arm and decided to make it stronger at the same time.
A picture was added showing the size difference between version 1 & 2.
I added a friction bolt to Center V3. Otherwise it is the same as V2.
I used the knurling bolts that was modeled by akira3dp0. Thankshttps://www.thingiverse.com/thing:1460364
I used the smallest bolt available and then scaled it down by 50%.
The head was still too thick so I reduced the head thickness by another 4 mm.
I have test printed all pieces and I am very satisfied with their fit.
They are scalable as long as you scale all 3 axis the same amount.
If you want to scale the flexible runners on the z axis to make them thinner that would be OK too.
Tight Tolerances, but everything will fit with a printer tuned correctly.
Supports will need to be fairly clean when removed.
If you have elephant foot on your prints they will need to be cleaned before piece will fit.
Single Saddle Stand - .12 Layer - 30% Infill
Print 1 of each of the following
Base -- 28.2 Meters PLA -- 20 hours 38 minutes -- Supports YES (from Platform Only)
Threads V2 -- 11 Meters PLA -- 8 hours 5 minutes -- Supports NO
Saddle -- 6.8 Meters PLA -- 5 hours 5 minutes -- Supports YES
Double Saddle Stand - .12 Layer - 30% Infill
Print 1 of each of the following
Base -- 28.2 Meters PLA -- 20 hours 38 minutes -- Supports YES
Threads V2-- 11 Meters PLA -- 8 hours 5 minutes -- Supports NO
Center V2 -- 13 Meters PLA -- 8 hours 56 minutes -- Supports YES
Print 2 of each of the following
Saddle -- 6.8 Meters PLA -- 5 hours 5 minutes -- Supports YES
Saddle Arm V2 -- 4 Meters PLA -- 3 hours 7 minutes -- Supports No
T Pin -- 1.2 Meters PLA -- 1 hours 7 minutes -- Supports NO
Plate Stand -- .12 Layer - 30% Infill
Print 1 of each of the following
Base -- 28.2 Meters PLA -- 20 hours 38 minutes -- Supports YES
Threads V2 -- 11 Meters PLA -- 8 hours 5 minutes -- Supports NO
Plate -- 24.7 Meters PLA -- 18 hours 2 minutes -- Supports NO
Print 2 of each of the following
Flexible Runner -- 18.7 Meters TPU -- 8 hours 30 minutes -- Supports NO
(8 mm thick can be scaled 66% or 50% to reduce thickness)