1104 Motor Skid by angelicgundam90

Last crawled date: 3 years, 1 month ago

Just a basic motor skid for 1104 motors or motors with m2 holes on a 9mm diameter hole spacing. The platform for the screw is 2mm thick. i use these with a 1.5 mm thick frame and mount my motors with m2x5mm screws. The holes are large enough to account for shrinkage so you shouldn't need to scale it up to get good fitment. i print with flat side down to ensure i have a smooth and level surface against the frame. They work well for sliding on hardwood floors and smooth concrete but would need some post print finishing to make them smooth enough to slide along hard pack carpet. i used nylon because i want to slide along the ground but if you just want them for landing gear you could probably print them if a flexible filament for a little cushion when you land