100x100x3 mm lithophane holder by shivackt

Last crawled date: 3 years, 1 month ago

100x100x3 mm lithophane holder
Hello every one
This is our another new design for 100x100x3mm lithophane holder
.
There are several lithophane designs available in thingiverse. So I decided to design a new one which takes less time to print at better quality. This lamp is powered by 5V Mobile charger to glow the lithophane by 1 Watt LED. I thank to All lithophane designs makers in thingiverse. Because I truly inspired and got to know from their works. (Special Thanks to Jaymake)
This one 100x100x3mm lithophane
The complete design is easy to assemble. The components required and parts to be printed as follows
Sl No Parts to be printed Quantity in Nos
1 Top holder 1 no
2 Bottom Holder 1 no
3 Lithophane 1 no
Sl No Components Required Quantity in Nos
1 Rocker Switch Small One 1 no
2 LED (1 W or similler) 1 no
3 Resistor 100 Ohm 1 no
4 Micro USB female connector. Panel mounting type 1 no
5 Heat shrink tube 4mm dia Req length
6 Favi stick
7 A mobile charger Micro USB type
Steps to follow:
• Use the attached JPEG as an original for the correct dimensions of the lithophane.
• Change the image to whatever you like (keep the format!)
• Go to http://3dp.rocks/lithophane/
• Upload your image
• Select "Flat"
• Go to settings > Model settings > Maximum size (MM) > Set it to 100 mm
• In case you did not upload a negative image: Go to settings > Image settings > positive image
• Click "Model" on top of the page
• Hit "Refresh" button
• Hit "Download" button to download and print your personal lithophane
Printing:
•Base required support to print.
LET ME KNOW, IF YOU MADE ONE ;-)
Print Settings
Printer:
Anet A8
Rafts:
Doesn't Matter
Supports:YEs
Resolution:
0.2 for lethophane
0.3 for all other parts
Infill:
20 - 30%