1" Cap cap by Doz1971

...spare cap for pattex epoxy by 3d_lover thingiverse spare cap for pattex epoxy cap resin cap hardener

...58mm lens cap holder nikon by gabigl thingiverse a cap holder for nikon caps or every 58mm cap

...cord cap / rope end cap by i6o6 thingiverse simple cap for the end of a rope. the knot in the rope will hide in the cap.

...pet keg cap, для пэт кеги; keg, cap thingiverse a cap for a pet keg to raplace the a a-type comercial cap.

...ngiverse extrusion 20x60 end caps. i use the cap without hole as foot and the other with hole as top cap so i can screw top cap.

...tinker cap thingiverse cap

...caps by mjk2203 thingiverse caps

...cap by artformer thingiverse cap

...x50 by malnormalulo thingiverse binocular cap rain cover shell binoculars caps protect cerlziess 10x50 diameter of caps: 62.4 mm

...бпц 20x60 by malnormalulo thingiverse binocular cap cover shell binoculars caps protect bpc бпц 20x60 diameter of caps: 77.30 mm

...this is a bracket to hold a replacement pcb mounted transformer into a ge superadio 3. see andydoz.blogspot.com for more details.

...cap-cap 3 pin 33.5mm od by doz1971 thingiverse capacitor cap to aid re-stuffing of the 3 pin cans on a leak stereo 20 amplifier.

...cap thingiverse cap antenna base

...tinker cap thingiverse cap

...caps by mjk2203 thingiverse caps

...cap by artformer thingiverse cap

...cap thingiverse 9

...snapback cap thingiverse snapback cap, for different headsizes just scale the cap up or down.

...capped by cheeba thingiverse just a cap

...rj45 cap thingiverse this is a rj45 cap

...oil cap thingiverse oil cap

...magic token +1/+1 & -1/-1 by kilgara2b thingiverse a magic the gathering token +1/+1 and -1/-1

...tudiosgaming thingiverse if you are in need of the 4pstudiosgaming +1/+1 and -1/-1 counters, then you came to the right page :-p

... 1/6, 1/8, 1/10, and 1/12 sized wedges as well as a circular base for them to fit onto. there are no labels on any of the pieces.

...dapter for syphon - 1 1/4" to 1 1/2" h10,5mm the project was realized with tolerances for printing with abs + tape ptf.

...l fit both 1 1/8" and 1 1/5" bearing cups. i used a 3/8ths" threaded rod with nuts and thick washers on each end.

...design cheeseborough clamp for hanging lightfixtures and other items onto 1-1/4"-1-1/2" npt pipe. use at your own risk.

...them instead of money coin in your supermarket cart or in your swimming pool locker. edit : updated 1£ coin with new dimensions

...d adapter 1" to 1" 1/4 by printerforever thingiverse this is an adapter 1" to 1" 1/4 (male to male) enjoy !

...playstation 2, 1:1 by vitting thingiverse made a 1:1 playstation 2.

...re thinner and actually fit within each other to show equivalent fractions. also, check out the same version with braille (here).