12 tomasw 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
Flashforge Dreamer handle by Tomasw
...lashforge dreamer handle by tomasw
thingiverse
this is a remix of http://www.thingiverse.com/thing:977666 a little simpler look.
thingiverse
free
Mobile monitor stand by Tomasw
... with some double-sided tape and you have a stand for your phone.
updated the stand so it works both in portrait and landscape.
thingiverse
free
Duplo to BRIO bridge connection (shorter print) by Tomasw
...ation of the flat-file from: http://www.thingiverse.com/thing:110221
it prints in about 2/3 of the time compared to the original.
thingiverse
free
Top mounted Makerbot 5th generation spool holder by Tomasw
...is for placing the spool holder on top of the machine and replaces the original base in: http://www.thingiverse.com/thing:508896/
thingiverse
free
Enclosure for Replicator Desktop 5th generation by Tomasw
...th generation is drafty. so i needed a way to stop the draft. in the cellar i found a plastic sheet 1mm thick from an old canvas.
thingiverse
free
Easier to print spool holder for Makerbot Replicator 5gen by Tomasw
...;w used an horizontal spool holder for a long while, but it tends to tangle the filament thread, this vertical seams much better.
thingiverse
free
32mm hose connection to sun heater WG-1000 by Tomasw
...giverse
i hade to few connectors between my solar heaters. this is used between the 32mm pool hose and the wg-1000 solar heater.
thingiverse
free
Flashforge Dreamer camera mount by Tomasw
...will se the print.
there are two iterations, the second is a little higher, test if it works in your dreamer and lett me know :).
thingiverse
free
Three extruder calibration by Tomasw
...hould be 20 mm.
print one layer or more, pause, measure, adjust offset, save and restart print until you have a perfect offset.
thingiverse
free
Higher mounted extruder RepRapPro mendel and tricolor mendel by Tomasw
...r.
the clamps just snap on to the body and you fasten them to the extruder with the same bolts and nuts as the original clamps.
thingiverse
free
6*4 mm tube cooling Mendel Mono and Tricolor by Tomasw
...heavy aquarium pump as well.
fit it to the forth extruder-place on the back of the machine with m3 nut and a 10-20 mm m3 screw.
thingiverse
free
35 degree Thorsman plate VGA, HDMI, 2 x Keystone by Tomasw
...ow. i also forgot to have more shallow wall around the vga because the adapter we use "female-female" has short screws.