10 randrews 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
ICBIP by randrews
...icbip by randrews
thingiverse
i can't believe it's printable!
thingiverse
free
Box 2.0 by randrews
...rse
same as the original box, but the hinges will fit without drilling, and the lid will open in the middle instead of one edge.
thingiverse
free
Cube construction kit by randrews
...cube construction kit by randrews
thingiverse
a square tile that fits with itself and can make structures, like this cube
thingiverse
free
Ikea LED light bracket by randrews
...ikea led light bracket by randrews
thingiverse
a bracket to hold led light strips from ikea to the bottom of shelves.
thingiverse
free
Box with lid by randrews
... things, like maybe cards. it uses a straightened-out paperclip for the hinge pin, and can be held closed with another paperclip.
thingiverse
free
Another Hexaflexagon by randrews
...el, so i decided to just make one of my own. this one is quite a bit easier to print, although it does require a little assembly.
thingiverse
free
Toy chain by randrews
...struction toy" because once it's constructed it can't be changed, but that's the category that matches the best.
thingiverse
free
Headphone peg for a command strip by randrews
...n easily remove them by yanking on the little tab. this is sized to be held up by a command strip, and hang your headphones from.
thingiverse
free
Mississippi Queen piece by randrews
...two dice, it has thin walls, infill, can be printed in about 10 minutes, and if it's going to fail you can tell pretty early.
thingiverse
free
Yes You Can Print A Spool Holder! by randrews
...o easily it's hard not to make one! all you need are two small prints, a few pieces of wooden dowel, and maybe some zip ties.