15 jeffrey892 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
Box by jeffrey892
...box by jeffrey892
thingiverse
just another box with lid and a handle.
thingiverse
free
Fluke 8020B Stand by jeffrey892
... by jeffrey892
thingiverse
one of my co-workers designed this at my request. it's the stand for my fluke multi-meter 8020b.
thingiverse
free
1" Rail Support by jeffrey892
... can slide them over an existing 1" railing. print in abs or filament with high heat tolerance. pla will soften in the sun.
thingiverse
free
Sunsetter Slide In Clips by jeffrey892
... or attach items to it. i used it to hang a set of lights.
i did a quick design in sketchup and printed 12 to attach the lights.
thingiverse
free
Telrad Mount for Green LED by jeffrey892
...se
print two, one for each telrad mount slot, and slide in your green led. print the always on light ring to keep the laser on.
thingiverse
free
Snap On Chair Bushing by jeffrey892
... so i designed this to work. printed it in pla. pound it in with a rubber mallet then insert the swivel wheel. it works great.
thingiverse
free
Flag Pole Holder Using Magnets by jeffrey892
...92
thingiverse
the magnets are 3mm deep and 8mm wide, made for five magnets. the holder is still designed for an 8mm flag pole.
thingiverse
free
RobCo Processor Widget Holder from Fallout 3 by jeffrey892
...robco processor widget holder from fallout 3 by jeffrey892
thingiverse
a socket for the robco processor widget from fallout 3.
thingiverse
free
LED Strip Holder by jeffrey892
... mount has been turned 90 degrees to mount to the cabinet. i used push pins to mount it to the cabinet. see my other led mount.
thingiverse
free
LED lighting strip bracket by jeffrey892
...r kitchen cabinets. i bought a package of thumb tacks from the local hobby lobby that fit nicely. i printed mine on their side.
thingiverse
free
Patio Table Umbrella Hole by jeffrey892
... i cut out the four center 1" tiles of a 12" square tile and replaced it with this so i can put an umbrella through it.
thingiverse
free
One-Up Electronics Carrier Feet by jeffrey892
...ou to raise the board off your table to allow wires to run underneath and let you bolt it to your table and keep it in one place.
thingiverse
free
One-Up Bed Adjust Nut Holder by jeffrey892
...d the nut. this one just slips over the bottom plate and holds the nut from turning. it fits tightly so it won't come loose.
thingiverse
free
Stinson 108 Instrument Hole Paint Covers by jeffrey892
... and not have to tape the area off with masking tape.
two sizes, one for the 3 1/8" holes and one for the 2 1/4" holes.
thingiverse
free
Nuts / Screws knobs by Shoyun
...you will like it :) edit february 2017, 06: jeffrey892 told me the fit was too loose, i uploaded...