12 cmnicholls 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
Lee 1000 primer deflector by cmnicholls
...ngiverse
device clips between the two right hand columns on the lee 100 and deflect the odd rouge primer in to the correct place
thingiverse
free
Replacement square powder hopper by cmnicholls
...s without tapping.
replaces the lee square hopper that is held on by self tapping screws and crack after a couple of disk changes
thingiverse
free
Sako TRG cheek piece packer by cmnicholls
...be raise by 2 of these before the cheek piece interferes with the action of the bolt. no idea if the problem occurs in the trg 22
thingiverse
free
Sabbatti Tactical Cheek piece mk2 by cmnicholls
...is not high enough if the scope is large.
this cheek piece solves both problems. could be used on any sabbatti tactical mmt rifle
thingiverse
free
Sabbatti Tactical Cheek piece mk1 by cmnicholls
...is not high enough if the scope is large.
this cheek piece solves both problems. could be used on any sabbatti tactical mmt rifle
thingiverse
free
Lee 1000 collator tray for .223 remington by cmnicholls
... before being glued together.
off the 2 i have printed on a da vinci jr have gone together with a press fit no tinkering required
thingiverse
free
TRG 42 Cheek piece by cmnicholls
...heek piece stops you doing this without removing it.
these cheek pieces solves both problems. could be used on any sako trg rifle
thingiverse
free
Lee 1000 spent primer collection system by cmnicholls
...ble side to allow easy emptying.
the hole to screw the bin to the stand is 4.5mm which can be drilled and tapped for a m5 thread.
thingiverse
free
338 lapua powder through die by cmnicholls
... thread is tricky to print.
this die fits into my press without any fettling and the standard lee nut screws on without a problem
thingiverse
free
308 single shot adaptor (bobsled) for the AI by cmnicholls
...orm down and slid the adaptor in at an angle
to remove, push the back of the adaptor down grab hold of the front end and pull out
thingiverse
free
338 single shot adaptor (bobsled)for an AI by cmnicholls
...zine slot then rotate it back.
to remove, push the back of the adaptor down grab hold of the front end and rotate and pull it out
thingiverse
free
Sabbati Cheek rest MK3 by cmnicholls
...machine screw and one m5 washer to fit the m x 20mm
i have printed this in pla but i have found abs or petg to be a better choice