12 chris24ed 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
144001 Bumper by chris24ed
...
thingiverse
wltoys 144001 bumper
fit main bumper then glue the small ramp underneath to protect the front of the chassis plate.
thingiverse
free
Axle plug by chris24ed
...ug by chris24ed
thingiverse
axle end plug to keep the dirt out of the hex pin grub screw in the end of the axles.
print from tpu
thingiverse
free
Body support washer by chris24ed
... chris24ed
thingiverse
rc body soft support washer.
print with tpu
infill 25%
infill line distance 1mm
infill pattern concentric
thingiverse
free
Body shell protection skid plate by chris24ed
...l protection skid plate by chris24ed
thingiverse
body shell skid plate. printed with tpu 80% infill with supports 40% concentric
thingiverse
free
Splashproof receiver box by chris24ed
...ep lid to give more protection.
bottom from any material. print top in tpu it is a tight fit to give better protection from water
thingiverse
free
Receiver box JLB Cheetah by chris24ed
...giverse
splash proof rx box. i printed the lid from tpu to give a bit of a seal effect
box - pla 50% infill
lid - tpu 50% infill
thingiverse
free
RC body clip protection washer by chris24ed
...used shoe goo or e6000 to glue them in place.
the hole is 6.2mm diameter but can be scaled in cura is a different size is needed.
thingiverse
free
C1 Chaser Flight controller deck remix by chris24ed
...ck with 30.5mm and 20mm hole spacing. to be used with the original, deck supports available from the it'sqv, c1 chaser parts.
thingiverse
free
JLB Cheetah Wing support bracket by chris24ed
... will need 1 x 30mm and 1 x 35mm nylon m3 standoff. the thin washer fills the gap between the top washer and wing support bracket
thingiverse
free
JLB Cheetah Toe, hub link / Chassis saver by chris24ed
... toe link rods will be needed along with m3 screws and nylock nuts to suit.
material -tpu
infill - 80%
infill pattern - triangles
thingiverse
free
RC car body shell mounting post protective oval washer by chris24ed
...d the mounting post holes.
designed for 6mm mounting post but can be scaled to fit any size.
glue on with shoe goo
print from tpu
thingiverse
free
JLB Cheetah Wing support bracket by chris24ed
...e spacers go under the large wing plastic washers to fill the space between the washers and wing support.
updated 24th march 2021