14 bjcomp2384 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
Pocket Siren fdm by bjcomp2384
...pocket siren fdm by bjcomp2384
thingiverse
you will need a post to spin the impeller on, a short bolt or stick.
thingiverse
free
360 speaker adapter restored by bjcomp2384
...red by bjcomp2384
thingiverse
when attached to a speaker, this should help to project the sound in man directions, not just one.
thingiverse
free
battery cap by bjcomp2384
...minals with my toes, and sending the electricity up one leg, and down the other. i use a webbing strap to hold it on the battery.
thingiverse
free
SnowSaw by bjcomp2384
... the result is rigid and sturdy, with a snug fit, be safe and have fun, please feel free to post prints and share if you like it.
thingiverse
free
FFR_BlazerFletchings_2Parts by bjcomp2384
...other design i have tested so far. (the trick it putting more material at the top of the head than in the rest of the projectile)
thingiverse
free
Extended Play U-joint by bjcomp2384
...d on top, allowing for better clearance, and more movement, when connected to my trolling motor, so i can drive from the cockpit.
thingiverse
free
HP monitor to VESA100 by bjcomp2384
... of the hp monitor stand, and requires m4 screws to attach the monitor bracket to the adapter, and the adapter to the vesa mount.
thingiverse
free
Trolling Troll(trolling motor extention) by bjcomp2384
...rinted this to attach to the handle of my trolling motor, and allow me to drive the kayak from my seat without pulleys and ropes.
thingiverse
free
Kayak Transom Mount Clamp Feet by bjcomp2384
...y transom mount for a trolling motor to a 10ft kayak. more pics once it is done, these replace the feet on my irwin quick clamps.
thingiverse
free
m570 Mouse Pad for 3d printing by bjcomp2384
...of laser cut it, so i imported into fusion 360, pulled it to 2mm thick, and saved it as an stl. i intend on printing this in tpu.
thingiverse
free
carbon arrow tent pegs_x6 by bjcomp2384
...stronger, and heavier, to use the glue to stabilize the arrow body for real use. also using field tips will give it a better tip.
thingiverse
free
Cannon Arrow by bjcomp2384
... pulled from the head rather than pushed from the tail, it should also reduce some of the arrows vibration as noticed by archers.
thingiverse
free
K-Kart(3D printed C-Tug) by bjcomp2384
...top pads on, and secure them better so i could bungee the cart to the kayak. i then used a couple of wood screws to hold them on.
thingiverse
free
waterquest Aruba 10 kayak transom contour plate by bjcomp2384
...er in the rear.
i have also now included a two halves version with the transom mount, and the rods to secure the pieces together.