11 Mikepcw 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
Unbreakable Sanguinololu Holder by mikepcw
...roat of the clevis.
pretty self-explanatory i hope :)
attach m3 screw and nut as shown to avoid damage to pcb once installed.
thingiverse
free
Sanguinololu Fan Mount (pushclamp mount) by mikepcw
...w.thingiverse.com/thing:158873)
simple enough, right?
see my other 'pushclamp' designs if in doubt on how to install.
thingiverse
free
NVIDIA Jetson TK1 sandwich board remix by mikepcw
...non printed parts in attached pdf bom (for australian electronics store, jaycar)
assembly instruction in attached illustration.
thingiverse
free
Z800 series double slot passive GPU fan duct by mikepcw
... superglue; apply duct tape where necessary.
probably needs to operate with side panel of z800 off to not choke the fan intake.
thingiverse
free
52mm Coffee Tamper with Hex Twist Handle by mikepcw
...y cup (and it can literally be used as a stamp too!)
you can try boolean cuts on this stl and achieve similar results, i guess.
thingiverse
free
Double slot passive GPU fan manifold v1.3 by mikepcw
...ackets may need to be bent out of the way to accommodate the width of the square end of part "a" where the fan attaches
thingiverse
free
Unbreakable Prusa Z-rod stabilizer constraint (push on, retrofittable) by mikepcw
...he other hole (closer to the throat) is intended for my fine adjustment end-stop mount (http://www.thingiverse.com/thing:158872).
thingiverse
free
External PCI bay extractor for ATX case by mikepcw
... seal around contact edges with pci bay
2x m3 hex head bolt
superglue
80mm or 92mm fan
be sure to read full instructions.
thingiverse
free
Unbreakable Bar Clamp (retrofittable) by mikepcw
...ned by 4 deg when printed (see drawing). this enables the clamp to pinch and friction lock against the smooth rod when tightened.
thingiverse
free
Z-stop Microswitch Fine Adjustment Mount by mikepcw
...
if you find it does not slide up when you loosen the wingnut, you need to sand the mating surfaces more or use a stiffer spring.
thingiverse
free
RepRap Samuel - Upgraded Mendel i2 by silpstream
...0mm supportless, directed cooling fan duct for mendelmax & prusa by aeromonkeydork - https://www.thingiverse.com/thing:63123