14 Capthowdy126 3d models found
Download or buy, then render or print from the shops or marketplaces.
3D Models below are suitable not only for printing but also for any
computer graphics like CG, VFX, Animation, or even CAD. You can print these 3d models on
your favorite 3d printer or render them with your preferred render engine.
Please note that the 3D model database is only a Search Engine. You should
visit the original websites. Most of the models can be easily imported and rendered
with Autodesk 3ds Max, Maya, Blender, C4D, and Sketchup. Check for online
3d model conversions tools for your file format.
thingiverse
free
LR44 Button Cell Battery Storage. by CaptHowdy126
...ther two positions.
i have created a smaller version to fit the right-front corner and the back-center.
a m3-.50 nut is required.
thingiverse
free
Filament Joiner by CaptHowdy126
...block its self to hold the ptfe tube while i slide a utility blade through the middle an it came out perfect on my first attempt.
thingiverse
free
Altoids Sized Case with Hinge by CaptHowdy126
... suggestions. i printed it with supports for the hinges but i think u could print without supports if you have good part cooling.
thingiverse
free
775 Spindle Storage Case by CaptHowdy126
... the bottom an a ring to go around the bottom so when its closed the top can sit against the ring an just gives it a bit of trim.
thingiverse
free
FT Mini Arrow by CaptHowdy126
...eps it from sliding. the tape is not holding it in place its just acting like a rubber surface between the two plastics surfaces.
thingiverse
free
vat drip stand for 2040 extrusion remixed by CaptHowdy126
...elf yet cause im still printing the parts out as i type this but as soon as its done i'll put it together an add the pictures
thingiverse
free
g16 socket for led lights by CaptHowdy126
...at id print it at in that case. but again its a simple model an simple to print so any settings should work no supports required.
thingiverse
free
FT Flyer Motor mount by CaptHowdy126
...l probably stay the same unless other feed back leads me to changing it an if i do i will have updates at the top of the summary.
thingiverse
free
3D Printed Toy Gun (Reload from PrintingIn3D 99) by CaptHowdy126
...harm or take any credit for this it came from printingin3d 99. here is his page,https://www.thingiverse.com/3dprinting_99/designs
thingiverse
free
Anet A8 Plus Bed Glass frame with strain relief by CaptHowdy126
...o fit. im also using 25mm long springs with m4x35 screws with the spring guides that lock into each other once compressed enough.
thingiverse
free
small trans bins 100mm - 150mm by CaptHowdy126
... up with used twice more filament so i was able to cut it in half while keeping it strong enough to not crack or break over time.
thingiverse
free
7000wm laser air assist by CaptHowdy126
...n mine so if u want u could increase its size by scaling it up by a few % an that might make it a little easier to get on an off.
thingiverse
free
FT Mini Arrow power pod with belly skid plate an motor mount by CaptHowdy126
... the original files but ill dig them up an will add them to the post so u can get them if you' would rather use one of those.
thingiverse
free
Ender-3 Bed Frame for Glass with Wire Strain Relief & Spring Guides by CaptHowdy126
...it might be to weak in that area for the strain relief. give it a try an let me know what u think. any suggestion is appreciated.