Thingiverse
ZZW30 MR-S MR2 Spyder engine cover vent grille by ianzz
by Thingiverse
Last crawled date: 4 years, 10 months ago
Engine vent ornament for ZZW30 MR-S MR2 Spyder engine cover vent grille
Use shortened file for 350mm bed size (ZZW30_Vent_LEFT_12mm_shorten.stl)
This file is 12mm tall so prints quicker than 16mm tall version
Else print 2 sides in 2 half pieces (4 total) for 220-250mm beds
Photo shows bottom left piece of 4
Type 1: Intersecting Bars
Type 2: Slatted Fins Venetian prototype/in progress (slats are far too thin on test sample)
Use shortened file for 350mm bed size (ZZW30_Vent_LEFT_12mm_shorten.stl)
This file is 12mm tall so prints quicker than 16mm tall version
Else print 2 sides in 2 half pieces (4 total) for 220-250mm beds
Photo shows bottom left piece of 4
Type 1: Intersecting Bars
Type 2: Slatted Fins Venetian prototype/in progress (slats are far too thin on test sample)