Thingiverse
Zortrax M200 Noctua Lower Fan Distance by SelTec
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a custom distance piece for the lower fan on the Zortrax M200.
The 40mm Noctua fans are a little bit higher than the original fan, so people have sometimes problems that the fan shroud hits the board connector, when using Noctua fans as replacement part.
You have to remove all 8 rubber bits on the Noctua fan and click this part into the fan.
It should give you the same total height as the original distance piece, fan and fan shroud.
On my printer this is ~23.1mm.
The 40mm Noctua fans are a little bit higher than the original fan, so people have sometimes problems that the fan shroud hits the board connector, when using Noctua fans as replacement part.
You have to remove all 8 rubber bits on the Noctua fan and click this part into the fan.
It should give you the same total height as the original distance piece, fan and fan shroud.
On my printer this is ~23.1mm.