Thingiverse
Zombicide: Black Plague token holder by Halfling13
by Thingiverse
Last crawled date: 4 years, 5 months ago
I could not find anything similar, so I ended up just designing one myself on Tinkercad. I store my game tiles in the accessory box, since I have foam filling the main box in order to hold painted zombies safely. I needed a way to organize and store the tokens, but still fit into the box with the tiles. This block fits between the large tiles and the edge without difficulty, and I just use a rubber band to hold the lid on.
The print fits just barely onto a 200mm bed, which was my design limit, and holds all tokens from the Zombicide: Black Plague core set, except for the round ones.
May still optimize it a bit further - the initial design does use a lot of material, but it is definitely functional.
Corrected the lid, apparently I had one of the slots a little too deep
The print fits just barely onto a 200mm bed, which was my design limit, and holds all tokens from the Zombicide: Black Plague core set, except for the round ones.
May still optimize it a bit further - the initial design does use a lot of material, but it is definitely functional.
Corrected the lid, apparently I had one of the slots a little too deep