ZMR 250 Spacer Kit , Tilted Motor Mounts by MoRayCH

Last crawled date: 2 years, 12 months ago

More Information on my original thread on RC Groups, : http://www.rcgroups.com/forums/showthread.php?t=2256768
Frame Spacer Kit :
7mm Spacer (4)
10.3 mm Clearance between lower & upper Frame
Requires M3 20mm Bolts, I only use 2 per Arm, strong enough.
LED Holder :
10.3mm LED Holder (2)
Use any LED strip with a maximum of 10mm height
Mounting either with double-sided Tape or Hotglue / CA from Hobbyking
There is also a simplified version available, without overhangs, and the groove has been removed, for easy printing.
I use the Turnigy High Density R/C LED Flexible Strip from Hobbyking, they are 8mm in height
10° Tilted Motor Mounts :
They are labeled with F (Front) and R (Rear).
Calibrate your Naze while LEVEL, then add 10° Pitch Offset via CLI : align_board_pitch = -10
1806 and 2204 Motors Supported.
Because of the Angle, you might have to slightly enlarge the holes on the arms.