Zelda Shield by Marcusdecarcus1

Last crawled date: 3 years, 4 months ago

First I want to give props to fasteddy516 for the design.
This was enlarged to print on a gMax XT+ for a full size shield. Defiantly use a brim or glue to hold down to bed, as it tends to lift. Pieces were put together with 2 part epoxy and 3/8" wooden dowel rods. Ratchet straps were used to clamp it together. Blend the seams together starting with Bondo brand fiberglass bondo and sanding. A few coats of high build primer with sanding in between. 2 coats of Rust-oleum stone texture finish and 2 coats of same brand matte finish clear. Size ends up about 3 ft tall, 2 ft wide, and 2.5 inches deep.